Scuba S3 puissance de nettoyage réduite — Diagnostic et solution
Reduced aspiration est le plus souvent causé par a obstrué filtre. If the robot flashes a LED rouge, the moteur de pompe may be stalled. Clean the filtre and check the turbine first.
Reduced puissance de nettoyage (weaker aspiration, debris left behind, slower movement) est le plus souvent causé par a obstrué panier filtrant. Remove the filtre, videz tous les débris, and rincer the mesh thoroughly under eau courante du robinet — use a hose or pressure sprayer if available, as débris séchés can be stubborn. If puissance de nettoyage is still weak AND the robot flashes a LED rouge, the moteur de pompe turbine may be stalled by trapped debris. Consult the manuel pour turbine access and inspection. If the filtre is clean and there is no LED rouge, the moteur de pompe itself peut avoir une fault requiring service après-vente.
Étape 1 : Deep-Clean the Filter Basket
Remove the panier filtrant from the robot. Empty all débris visibles. Rinse under eau courante du robinet, using your fingers to rub the mesh gently and dislodge particules piégées. For filtres that have not been cleaned in several cycles, débris séchés can clog the mesh — use a tuyau d’arrosage with a buse de pulvérisation for stronger rincering. N’utilisez pas soap, detergent, or solvents. Allow the filtre to sécher à l’air libre completely before réinsérering. A wet or damp filtre restricts airflow and reduces aspiration noticeably.
Étape 2 : Check for Red LED — Pump Blocage du moteur
If the robot flashes a LED rouge while operating, this indicates a motor fault — most commonly a stalled turbine de pompe. Turn off the robot, remove the filtre, and inspect the turbine area (refer to the manuel d’utilisation for the exact access procedure on the S3). Look for hair, string, leaves, or small stones jammed in the turbine blades. Carefully remove any debris with tweezers — do not use metal tools that could damage the turbine. Reassemble and test. If the LED rouge persists after clearing the turbine, the moteur de pompe itself peut être endommagé.
Étape 3 : When It’s a Pump Motor Fault
If the filtre is clean, the turbine is clear, and there is no LED rouge, but aspiration remains weak, the moteur de pompe peut avoir unen internal fault (internal wear or electrical failure). This type of fault requires réparation professionnelle. Contact support après-vente Aiper with your device numéro de série (SN), a description of the symptoms, and l’applicationroximate age of the robot. Pump motor issues peut être couvert under garantie if not caused by misuse.
.webp)
