Scuba S3 Hört auf zu arbeiten Mitten im Zyklus — Diagnosis & Fix
Three possible causes: niedriger Akkustand, motor stall, or the cycle simply completed. Check the LED indicator and Periodic Cleaning settings first.
When the Scuba S3 stops mitten im Zyklus, check these three causes in order: (1) Low Akku — if the robot ran its full erwartete Dauer, this is normal behaviour; reladen and resume. (2) Motor stall — check for a red flashing LED; if present, retrieve the robot and inspect the pump impeller and drive wheels for jammed Schmutz (hair, string, stones). (3) Cycle completed — if Periodic Cleaning or a Zeitplan was set in the app, the robot may have simply finished its programmed session. Check the app for the cleaning log.
1. Niedriger Akkustand — Normal Shutdown
The most common and benign reason: the Akku seine Mindestschwelle erreicht hat and the robot performed a normale Abschaltung. The Scuba S3 is designed to stop and park when the Akku is depleted. If the robot had been running for approximately its erwartete Dauer (check your specific mode’s angegebene Laufzeit), this is expected behaviour. Retrieve the robot, reladen fully and redeploy. If the robot viel früher als erwartet stoppte, see our Anleitung zu kurzer Akkulaufzeit.
2. Motor Stall — Rote LED-Warnung
If the robot stopped plötzlich AND the LED is flashing red, ein Motor blockiert ist. The most common causes: (a) the pump impeller is durch Haare, Schnüre oder kleine Fremdkörper blockiert ist; (b) a drive wheel is obstructed. Retrieve the robot, turn it off, and inspect the impeller through the filter compartment and each drive wheel for verwickelter Schmutz. Entfernen Sie Verstopfungen vorsichtig (use Pinzette, not Metallwerkzeuge). After clearing, einschalten and im flachen Wasser testen before Einsetzen im tiefen Bereich. If the red LED persists nachdem alle sichtbaren Verstopfungen beseitigt wurden, the motor itself may be damaged — contact support.
3. Cycle or Zeitplan Completed
If you use Periodic Cleaning (geplante automatische Reinigung) or set a bestimmte Dauer in the Aiper app, the robot may have simply finished its programmed session. Open the Aiper app and check the cleaning log or history — it will show whether the cycle completed normally. A ‚Completed‘ status confirms the robot stopped because it finished its work, not because of a fault. Passen Sie den Zeitplan oder die Dauer an in the app if you need längere Reinigungssitzungen.
When to Contact Support
Contact Aiper after-sales support if: (a) the red LED persists after clearing all visible motor obstructions, (b) the robot stops in jedem Zyklus sehr früh despite a vollständige Ladung, or (c) the robot stops but gar keine LED-Aktivität zeigt (möglicher interner Fehler). Provide your device serial number (SN), the verwendeten Reinigungsmodus, the ungefähre Laufzeit vor dem Stopp, and the LED-Verhalten (Farbe, Blinkmuster).
